Contact a Takeuchi dealer for sounds an alarm when an excessive load is maintenance. The following operations are particularly dangerous. Remove the four bolts from the cover 3. Doing so will cause engine breakdown. Use the grease gun to lubricate the grease nipples. Use the grease gun to supply grease to Lubricating the Levers the grease nipples 4. Turn the set screw 2 back to its original experience.
This website is not associated with any product manufacturer mentioned in any way. Wipe off the expelled grease. To The system will return to the audio source cancel the function, follow the procedures selected last. Please visit our to see a complete list of all the useful service manuals we offer. Check for oil and water leakage and inspect the working equipment, covers and lower body. Start and run the engine at low idle Auxiliary Hydraulic Lines with no load for 10 minutes.
Disconnect the other clip of jumper cause engine problems. Gripping the set screw 2 with a hexagonal wrench so that it does not Procedure turn together with the lock nut 3 , tighten the lock nut 3. Start the engine and run it at low idle for the vent plug 2 , adding hydraulic oil to 10 minutes. N0A006 When towing, selecting the wrong wire rope, inspecting improperly, or towing in the. Water Temperature Gauge This gauge indicates the temperature of the engine coolant water. Tilt the right lever forward.
If it should be lost or damaged, immediately order a new one from your Takeuchi dealer. Be very careful when slewing and L4D013 swinging sideways. Inspecting and Adjusting the Inspecting the Engine Fuel Engine Valve Clearance Injection Valve This operation requires experience. Tighten the rubber crawler to the standard tension. Do not open the engine hood, mud guard or cover on slopes or in strong wind.
There are other safety signs in addition to the ones listed here. Slew the upper structure so that the dozer blade is positioned to the rear of the body so that the crawler frame and upper structure are parallel. Do not open the engine hood or guard on slopes or in strong wind. Recharging Have a Takeuchi sales or service outlet recharge batteries that have gone dead. Slowly turn the vent plug 2 to release the internal pressure, then remove.
Press the right side of the pedal. If the problem persists after the above procedures are taken, contact a Takeuchi sales or service outlet for repairs. Line up the turn prevention holes, install the bolt 1 , and the nuts. To extend the arm: To swing right: Tilt the left operating lever forward. When replacing the important parts, please contact a Takeuchi sales or service outlet.
New machine are delivered with Takeuchi genuine hydraulic oil 46, and the hydraulic oil replacement intervals indicated in this manual assume that Takeuchi genuine hydraulic oil 46 is being used. Fully lower the safety lock lever s to move in unexpected ways. Clean following the other parts of the machine are hot instructions included with the cleaning directly after the engine is stopped. Bring the hoe attachment close to the body. Move knob 1 up and down or left and right Heater Fan Switch to adjust the direction of the air.
Add hydraulic oil up to the middle of the sight gauge 1. Gradually remove the dirt from the side of the mound. This manual should be kept near the machine for reference and periodically reviewed by all personnel who will come into contact with it. Turn the lamp off when leaving the machine. Failure to do so can cause injury or death.
If the charge is low, contact a Takeuchi sales or service outlet to After Cold Weather is Over have the battery charged. . Consult a Takeuchi sales or service outlet. Check that the rubber crawler is securely engaged on the sprocket and idler. Make sure the machine never contact a Takeuchi sales or service outlet faces sideways with respect to the for inspection. Press the left side of the pedal.