Defective oil pump or clogged oil circuit Replace or clean. Tighten each bolt a little at a time to equalize the pressure in the following two steps. Never perform any servicing until the nitrogen gas pressure has been released from the rear shock absorber unit. Indicator light Immobi-antenna Indicator light. Clean and lubricate every 1 000 km 600 miles. Leakage of brake fluid from hydraulic system Repair or replace.
Reinstall the engine by reversing the removal procedure. If any damage is found, replace the caliper with a new one. This combination meter is light, thin and of high response compared to those currently in use because of this composition. Do not use mix different types of fluid such as silicone-based or petroleum-based. Therefore, it is possible to know engine and driving conditions e.
If any defects are found, replace the shock absorber with a new one. Worn tappet or cam surface Replace. Connect the probe as shown to avoid opening of female ter- minal. Refer to page 2-31 for the loca- tions of the following nuts and bolts on the motorcycle. Not enough engine coolant Add coolant. Step 2 1 Check the battery for current leaks. Remove the brake fluid reservoir cap 2.
Weak- ened spring result in reduced engine power output, and often account for the chattering noise coming from the valve mecha- nism. Loss of balance between right and left front forks Adjust. Before inserting each piston into the cylinder, check that the gaps are so located. There is no fuel return hose. Set the fuel tank drain hose and breather hose with 2 Fuel tank breather hose lengthwise backward.
When the fast idle cam is turned by the secondary throttle valve actuator, the cam pushes the lever on the throttle valve shaft causing the throttle valve to open and raise the engine speed. Apply or use brake fluid. If this is not available, use an equivalent which is compatible with an aluminum radiator. At this time, if an operation sound is heard from the cooling fan relay and cooling fan motor is operated, the function is normal. Loss of tappet clearance Adjust. Too narrow spark plug gaps Adjust. If the distance between the rim line and wheel rim varies, this indicates that the bead is not properly seated.
Suzuki recommends to use this standard drive chain as a replacement. Engine removal is sequentially explained in the following steps. Valve clearance out of adjustment Adjust. Do not support the motorcycle with exhaust pipe. Keep heat, spark and flame away. If the speed sensor and connection are functioning properly, replace the meter with a new one. Mileages are expressed in terms of kilome- ters, miles and time for your convenience.
Do not use mix different types of fluid such as silicone-based or petroleum-based. The color on each lead wire refers to the appropriate fuel injector. Worn and burnt camshaft journal Replace. Such oil can damage the O-rings. Inverted telescopic, coil spring, oil damped Rear suspension. This fuel injec- tion system is precision designed, manufactured and adjusted to comply with the applicable emission limits. Not enough pressure in tires Adjust.
Replace the injector with a new one. If the distance exceeds the 1 2 3 19 20 21 service limit, the chain must be replaced. Battery has been left in a run-down condition for Replace the battery. If engine coolant is leaking, visually inspect the mechanical seal and seal washer. It is highly recommended to replace a tire when the remaining depth of tire tread reaches the following specification.