When the menus or the Viewer tool bar is not displayed, these buttons can be used to select a slide, or to move the cursor in Folder List or Slide List. Press again to restore the image and sound. Freeze Drag Capture Exit 3. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. The light being projected from the lens is extensive, therefore any kind of abnormal objects that can redirect light coming out of the lens, can cause unpredictable outcome such as fire or injury to the eyes. Turn on the projector and the computer.
When moving the projector or when it is not in use, cover the lens with the lens cap. Lamp or filter cover error 3 locations Steady orange Blinking red 1 sec interval The projector is in standby mode and can- not be turned on. . . However, if you would like to, you can change your settings at any time using the Change cookie settings link in the menu.
. It is recommended that you use a commercially available distribution amplifier if connecting a signal cable longer than the supplied one. This screen gives you the opportunity to select one of the seven menulanguages: English, German, French, Itilan, Spanish,Swedish and Japanese. Direct Button Volume Bar and Keystone Bar. Make sure your box contains everything listed.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Enter Button Executes your menu selection and activates items selected from the menu. Auto Play Interval:You can specify interval time between 5 and 300 seconds. Deletes a captured slide s or all the captured slides in theCapture — specific folder. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. InstallationInstall the viewer software as described below.
. Do not attempt to install the projector yourself. . . Displays a list of folders while you are playing back.
If this happens, be sure to replace the lamp. . . Insert a new lamp housing until the lamp housing is plugged intothe socket. Secure it in place with the two screws. To connect the mouse output port:1. But before you get started, you must first: 1.
. . The remote control can be used wirelessly. . Ensure that the projector is square to the screen.
. To cancel this feature, press any one of the buttons other than the Mouse button. Move the projector left or right to center the image horizontally on the screen. You canalso specify Auto Play Interval between 5 and 300 seconds. Turn off the power to your projector and computer. The information should be read carefully to avoid problems. .
. . When the pointer is displayed, the image is magnified about the center of the pointer. E-23 About Startup screen Menu Language Select screen. Press the Enter button to execute the selection. E-14 Adjusting the Tilt Foot. Do not place your projector in direct sunlight, near heaters or heat radiating appliances.