It was the turn of their own development, although the design of engines and other complex parts. The problem is that once you have gotten your nifty new product, the hyosung comet 125 2002 2010 service repair manual gets a brief glance, maybe a once over, but it often tends to get discarded or lost with the original packaging. Remove the steering stem head nut and take off the steering stem upper bracket Remove the steering stem nut and draw out the steering stem. In 1994, debuting a small cruiser Hyosung Cruise 125 with single-cylinder four-stroke engine 124 cm3, 14. If the valve clearance is within standard after measured the valve clearance, begin the next operation. Add distilled water, if the battery white powdery has not been damaged and substance or spots sulfation has not advanced on surfaces of too far, and recharge. Remove the gear position switch.
This will give a good indication of the condition of the moving parts. Worn piston ring or cylinder. An unleaded gasoline type is recommended. Valve timing out of adjustment. Clutch lever holder Front brake lever holder Drive chain Throttle cable Side stand pivot and spring hook Rear brake pedal pivot Speedometer gear box - Motor oil,. Rear axle nut : 90~140 N m 9.
It make it easy for any skill level with these very easy to follow, step-by-step instructions! Install the clutch drive plates and driven plates. Thread Lock 1324 Rotor holder : 09930-44510 Starter clutch bolt : 15~20 N m 1. Put on the housing A to the A of head surface, the housing B to the B , the housing C to the C and the housing D to the D as that A C D is punched also to the cylinder head upper surface. The text of this manual is divided into sections. Disconnect the fuel hoses Remove the fuel pump mounting bolts.
Remove the damper rod and rebound spring from the inner tube. Refer to page 6-1 Remove the fuel tank. Pressing the starter switch on the right handlebar switch energizes the starter relay, causing the contact points to close, thus completing the circuit from the starter motor to the battery. Loosen the four cylinder head stud bolts. If the measurement exceeds the service limit, replace the piston. If any defects are found, the fuel hoses must be replaced.
If the continuity measured incorrect, replace the respec- tive part. Side stand not coming up far enough to disengage switch. Hello, I own a Hyosung gt 125 comet its a 04 plate. Loosen the front axle Raise the front wheel off the ground with a block or jack. Good luck and have a wonderful day. In case separate oppositely, the gearshift cam stop- per will be damaged in the side of magneto. See page 6-36 Remove the swing arm pivot nut.
Failed kickstand safety switch circuit diode. Worn bearing or race in steering stem. Fit the piston ring into the groove. Refer to page 6-1 Inspect the fuel hoses for damage and fuel leakage. Use the pin to remove carbon, taking care not to damage the porce- lain. Tighten the rear axle nut to the specified torque. Loosen the bolt and remove the link rod.
Refer to page 6-1 Remove the fuel tank mounting bolt, and take off the hooks. The valve clearance specification is different for intake and exhause valves. Do not use a brake fluid kept in an open container or stored for long period of time. Conrod holder : 09910-20115 Remove the magneto rotor by using the special tool. I unit, side stand switch, gear position switch, starter switch, engine stop switch, ignition switch and battery. These numbers are required especially for registering the machine and ordering spare parts.
Loosen the switch fitting screws and adjust the timing by moving the switch body forward or backward. Install the brake master cylinder. Thickness gauge : 09900 - 20806 0. Without such knowledge and skills, you should not attempt servicing by relying on this manual only. Primary gears worn or rubbing.
Remove the fuel pump lead wire coupler. Extreme care must be taken. Good luck and have a nice day. Disconnect the brake lamp switch lead wire coupler. Therefore still based on licenses Suzuki. .