Align the tabs on the diffuser with the slots in the vent Insert the type C screw in the hole in the diffuser to panel. When it runs out, the unit just runs the fan until enough air has been condensed. I just experienced this problem myself. Always read and follow all safety messages. It probably does have power to the unit if the receptacle.
The appliance will stop operation automatically after operating for 8 hours. What helped me was cleaning out the lint trap. Answered on Jul 07, 2018 Check the outlet to make sure there is 110 volts to receptacle. To attach the mounting bracket to one end of the vent hose, insert the extended folds on one side of the vent hose between the ridges inside one side of the mounting bracket. Slot 2 Slide 1 Insert Align the tabs on the diffuser with the slots in the vent Insert the type C screw in the hole in the diffuser to panel. In this case the electronic circuit panel is bad, which means replace with a new circuit controller.
The fan speed is automatically set to Low. This symbol alerts you to potential hazards that can kill or injure you and others. My guess is that the until sucks in air through there, then conditions it. Soon as I popped it off, the unit started belching out cold air nonstop. If there is power there than you will have to check inside the unit to make sure the cord is delivering power to the unit. This is the safety alert symbol.
We have provided many important safety messages in this manual and on your appliance. If the filters are heavily soiled, they can be washed in warm water using a mild detergent. Select the panels required based on the window opening, as shown above. Answered on Jun 10, 2014 I think what you're seeing is actually a E2 error code. When it can't suck a decent amount of air in, the condenser can only condense so much of that limited amount of air.
The air filters are dirty. Do not use the remote if the battery has leaked. This function gives you a more comfortable environment for sleep. . Use a pliers to extend the first four or five accordioned folds at both ends of the vent hose. Blows the cold air out the top, and hot air out the tube.
My lint trap was filthy, hadnt Bern cleaned in years. Make sure the outlet of the hose is aimed away from nearby surfaces that could be stained or damaged by the draining water. The remote and the control panel are not in sync. For best results when using the remote, remember to check that all desired settings are correct on the remote as well as on the control panel. If only the Cool mode is used, the drain hose is not needed. Answered on Aug 17, 2012.
Do not use it for special purposes such as maintaining pets, food, precision machinery, or art objects. Install the security bracket with a type B screw as shown, it desired. . . .
. . . . . . .
. . . . . . .
. . . . . . .