If it does not locked, reinstall the hose joint. Inlet Air Pressure Sensor 3. Miscellaneous: Subthrottle sensor trouble Inspect see chapter 3. If the clearance is between 0. Therefore the cutter must not be used for other purposes than seat repair. Good luck and have a wonderful day.
If the shock absorber does not smoothly stroke or noise is found, inspect the oil leak see Rear Shock Absorber Oil Leak Inspection. If the fan does not rotate, the fan motor is defective and must be replaced. Piston Ring Groove Width Standard: 0. Gear seized on the shaft. Inlet Air Temperature Sensor 11. Ps: Standard Atmospheric Pressure abs.
If there is any doubt as to the condition of the reed, replace the air suction valve as an assembly. Clamp Clamp the right turn signal lead, and insert the clamp to the middle air inlet duct. Torque - Front Fork Clamp Bolts Lower : 30 N·m 3. Learn and ob- serve all the rules below. Road Clearance 125 mm 4. A tester other than the Kawasaki Hand Tester may show different readings.
If the connector is corroded or dirty, clean it carefully. Ignition Switch with Immobilizer Antenna Immobilizer Models 4. If the seal is torn or is leaking, replace the bearing. If whitish cotton-like wafts are observed, aluminum parts in the cooling system are corroded. If the fan does not rotate, the fan motor is defective and must be replaced. Battery 12 V 14 Ah 6. Run the fuel tank drain hose above the brake pipe.
Run the fuel tank drain hose above the brake pipe. If any wiring is poor, replace the damaged wiring. If the engine starts, inspect or replace the following item. Apr 17, 2012 Hi, Anonymous and the usual suspects are: 1. Engine Oil and Oil Filter. Apply the oil to the O-rings so that the O-rings will be coated with oil. Overall Height 1 170 mm 46.
If any wiring is poor, replace the damaged wiring. G: Apply grease to the threads. Crankshaft Main Bearing Insert Thickness: Brown 1. This valve seat cutter is developed to grind the valve for repair. Inlet air temperature sensor trouble Inspect see chapter 3. Immobilizer Amplifier Failure When Registered User Key is Inserted. Rear Wheel Rotation Sensor 4.
Inlet air pressure sensor trouble Inspect see chapter 3. Good luck and have a wonderful day. Water-proof Joint 2 If you need to check the inlet air pressure sensor for vac- uum other than 76 cmHg abs. Through the throttle cables to the clamp of the reservoir bracket. L: Apply a non-permanent locking agent. If the fluid level is lower than the lower level line, fill the reservoir to the upper level line in the reservoir. The headlight does not go on when the ignition switch and the engine stop switch are first turned on.
If they are damaged, replace them. Make sure the area is well-ventilated and free from any source of flame or sparks;. Front Wheel Rotation Sensor Rotor 3. Dimmer Switch High Beam 15. To the fitting of the throttle body 3. When the engine starts, the water pump turns and the coolant circulates. Such a shock to the pump can damage it.
Rear Wheel Rotation Sensor Lead Connector The wheel rotation sensor lead is joined with other harness in this connector. Center Stand Grip Equipped Models G: Apply grease. Through the headlight lead into the clamp both sides. This en- ables to check a long harness for continuity. .