Crankcase bolt: 11 N·m 1. If any dam- age is found, replace the odometer gearbox with a new one. E-03, 28 Remove the rear axle nut. Squeeze and release the brake lever several times in rapid succession and squeeze the lever fully without releasing it. Spark plug is wet or 1.
When inserting each valve into the valve guides, make sure not to damage the lip of the oil seal. Remove the master cylinder reservoir cap and diaphragm. Abnormal gas pressure cannot provide normal performance of the rear shock absorber. If any damages are found, replace the swingarm with a new one. Telescopic, coil spring, oil damped, rebound damping force 18-way adjustable, compression damping force 14-way adjustable Rear suspension.
The metered fuel enters the needle jet 4, mixes with the air admitted through the main air jet 5, and then forms an emulsion. When installing the balancer driven gear, align the pin 3 with the groove 4. Install the new brake pads. Tighten the drain plug 2. . The text of this manual is divided into sections.
If any clearance reading exceeds the service limit, replace both the piston and piston rings. Keep heat, sparks, and flames away from gasoline. Indicates a potential hazard that could result in death or injury. Cable 1 is for pulling and cable 2 is for returning. Do not remove the circrip A, before separating the crankase to prevent the oil pump idle gear shaft from dropping into the crankcase.
Remove the crankshaft from the crankcase using the spe- cial tool. The fuel in the float chamber 2 is metered by the main jet 3. If the resistance is not within the specified value, the pickup coil and signal coil must be replaced. Take clearance read- ings at several places. Telescopic, coil spring, oil damped, rebound damping force 18-way adjustable, compression damping force 14-way ad- justable Rear suspension. Tap the coated seat with the valve face in a rotating manner, in order to obtain a clear impression of the seating contact.
Insufficient amount of engine oil. The fuel from the float chamber 2 is metered by the pilot jet 3 where it mixes with air coming in through the pilot air jet 4. Also, apply engine oil to the camshaft journal holders. Replace every 60 hours of operation. .
Install the right and left driveshaft bearings using the special tool. Good luck and have a wonderful day. If there is excessive play, re- place the bearings with new ones. The oil should be changed while the engine is warm. If the voltage reading is less than the 12. The steering should be adjusted properly for smooth turning of the handlebar and safe operation. .
Remove the front axle nut 1 and loosen the front axle pinch bolts 2. Remove the valve spring seat. If this is not available, use an equivalent antifreeze for aluminum radiators. Gasoline is highly flammable and explosive. The electric starter is working but starter clutch has failed. To adjust the cable play, adjust the returning cable first and then adjust the pulling cable. Pivot shaft nut: 77 N·m 7.