For soft-top vehicles, cut 6 feet for the doors and 5 feet for the body opening. Lubricate lifters with oil and install in cylinder block. Install rear crossmember and secure transmission mount to adapter. Use of tire bead seater may be required. .
Clear obstruction with water spray and High Side High compressed air. One of the most common is a hissing sound most evident at standstill parking. Removal Connect harness lead to audio harness connector Remove engine cover console. Remove U-bolts, attaching rear shaft to rear axle yoke 10. Valuable upgrades to look for in a '95.
It is then drawn through the filter and transmission case into the table. Replace switch assembly if failed. Apply a light coat of brake compo- Removal nent lubricant on adapter slides. Push brake through open end of drum and remove Figure 9-165. Air leak in fuel delivery system.
Install heat shield and exhaust manifold on cylinder head and tighten capscrews to 25 lb-ft 34 N¥m. Check, repair cables or connections. Remove oil cooler attaching nuts and washers. Remove drain plug and drain oil from transfer case. Rivets can tolerate only 0.
Remove converter housing upper cover. Apply a thin coat of grease to boss protruding side of play. Retighten the inner 12 mm bolts to 55 lb-ft 75 N. Red This is a colorless, odorless non-flammable, liquefied gas. Much more driveable and quieter than the diesels and without all the headaches of the 6. Install the O-ring seal above the threads at the bottom of jacent to the fuel shut-off solenoid. Remove stem seal from valve and slide valve out of guide and head.
Leave vehicle on rack for toe settings and steering stop 2. Remove filler cap from filler spout Figure 10-123. If fluid is contaminated, flush system with clean brake Replace brake pads as axle sets front or rear if any pad fluid. Tachometer mounting Pull front console away from dashpad enough to gain clamp must be installed in factory position to have proper access to wiring harness connector. Compress thrust screw retaining ring with fingers and install it in caliper bore below piston seal groove. Optical sensor 5 volt reference 05745159 4-1-00. Adjust camber angle by rotating the front eccentric of the Preferred camber for all Hummer vehicles is zero to +0.
Remove remaining valve assemblies in same manner. Then disconnect shaft yoke Figure 9-104. The leak point could be at a brakeline, fitting, hose, or caliper. Apply sealer to front cover as follows: 1. These fasteners are installed in their holes with an inter- rivet, if possible.
Drain and reÞll tank with better quality fuel. This label is affixed to the air cleaner housing Figure 1-1. Remove fill plug and washer from geared hub Figure 9-18. Remove radiator and fan shroud. . Pressure should be a minimum of 6 psi 41 kPa at hot idle and increase to 30 psi 207 kPa at 2000 rpm. Drain engine coolant below level of water crossover.